LEE – TURRET 3-HOLE FOR TURRET PRESS/PRO 1000

Extra toolhead for Dillon RL550 and AT500 reloading presses.  Includes one toolhead only.

The Lee App Bulge Buster Kit and the appropriate Lee Carbide Factory Crimp Die, restore free function of rimless cases that have low base bulges. Low base bulges usually occur from chambers that do not fully support the cartridge or cases resized in carbide dies from manufacturers other than Lee. These show a noticeable stop ring near the base. You will most likely find cases with these problems in mixed range brass.

**Will work with the following cases:

• 380 ACP
• 10mm
• 40 S&W
• 41 AE (Use 40 S&W Factory Crimp Die)
• 45 ACP
• 45 GAP
• 45 Win Mag

The Lee Carbide Factory Crimp Die must be purchased separately. 

Part TF3567 for products: 90064 CLASSIC TURRET PRESS and 90932 4 HOLE TP WI AUTO INDEX. This part installs inside the black auto index clamp on the steel ram. The square black ratchet rides on the 1/4"x 1/4" steel index rod. In order to maintain the integrity of the square ratchet, remember to raise the ram which disengages the ratchet from the housing and allows the index rod to spin freely. It is at this point that the Turret can be removed and installed at will. Put some household oil between the 4 hole turret and 4 hole turret ring to extend the life of your square ratchet.