Dillon RL 550 / AT 500 Toolhead Blue Anodized Aluminum
$90.00
Product Information
Extra toolhead for Dillon RL550 and AT500 reloading presses. Includes one toolhead only.
3 in stock
Related products
Hornady – DELUXE DIE WRENCH
Product Information
The Hornady Lock-N-Load Deluxe Die Locking Ring Wrench is an ideal tool for your Lock-N-Load AP Press or for any Hornady die sets. The wrench is designed to hold the shellplate in place and keep it from slipping when adjusting the plate and securing it to the press. It also has three flats for tightening dies, spindle locks, and lock rings.
Hornady – LOCK-N-LOAD DIE BUSHING (2-PACK)
Product Information
Lock-N-Load lets you switch from one die to another and begin reloading in seconds. No threading dies in and out or adjusting is necessary. The positive locking action of the bushings holds the dies in rock solid, perfect alignment. You'll want a Lock-N-Load bushing for every die you use. This is a 2 Pak.
LEE – BENCH PLATE
Product Information
Lee Bench Plate allows for quick press removal without unbolting from bench. Includes 1 steel base block that fits all current Lee metallic presses. Special elevator bolt hardware included. Powder coated, thick steel mounts quickly and securely to any bench or tabletop. Wide steel plate distributes load, adding rigidity to the lightest bench top.
LEE – Roller Handle Upgrade Kit
Product Information
Pro 1000 and Turret Press roller handle upgrade kit includes everything you need to upgrade your ball grip to an ergonomic foam roller handle grip and all steel linkage. This handle can not be used on the Classic Turret Press, Breech Lock Classic Cast, Classic Cast, Load-Master or Reloader Press NOTE: This handle upgrade does NOT work on the Classic Cast Turret Press or the Classic Cast ''O'' Frame Presses.
LEE APP BULGE BUSTER KIT w/o CARBIDE FACTORY CRIMP
Product Information
The Lee App Bulge Buster Kit and the appropriate Lee Carbide Factory Crimp Die, restore free function of rimless cases that have low base bulges. Low base bulges usually occur from chambers that do not fully support the cartridge or cases resized in carbide dies from manufacturers other than Lee. These show a noticeable stop ring near the base. You will most likely find cases with these problems in mixed range brass.
**Will work with the following cases:
- 380 ACP
- 10mm
- 40 S&W
- 41 AE (Use 40 S&W Factory Crimp Die)
- 45 ACP
- 45 GAP
- 45 Win Mag
The Lee Carbide Factory Crimp Die must be purchased separately.
Reviews
There are no reviews yet.