LEE – CASE COLLATOR FUNNEL
$19.75
Product Information
The Lee Case Collator can fill all four Lee Case Feeder Tubes in just 10 seconds. Brass falls base down into the drop tubes, making progressive reloading with the Pro1000 or Load-Master presses that much easier. To use lay cases in collator and they will fall base down into the drop tubes (not included)
2 in stock
Product Information
The Lee Case Collator can fill all four Lee Case Feeder Tubes in just 10 seconds. Brass falls base down into the drop tubes, making progressive reloading with the Pro1000 or Load-Master presses that much easier. To use lay cases in collator and they will fall base down into the drop tubes (not included)
| Weight | 1 lbs |
|---|---|
| Brand |
LEE |
Only logged in customers who have purchased this product may leave a review.
Related products
Hornady Reloading Counter Mat 17″ x 26″
Product Information:
The Hornady Reloading Counter Mat is the ultimate reference tool for your reloading bench. This non-skid bullet mat features the entire line of Hornady bullets with corresponding caliber, diameter, weight, ballistic coefficient, sectional density and Hornady's item number. The Counter Mat also doubles as a cleaning and maintenance mat, protecting your work bench from solvents and oils. The slick plastic finish on the mat will not absorb solvents and oils, and cleans up quickly. If you are a serious reloader, pick up your Hornady Reloading Counter Mat today. Features- Features Hornady's full line of bullets!
- Non-skid neoprene back
- Slick plastic top
LEE – BENCH PLATE
Product Information
Lee Bench Plate allows for quick press removal without unbolting from bench. Includes 1 steel base block that fits all current Lee metallic presses. Special elevator bolt hardware included. Powder coated, thick steel mounts quickly and securely to any bench or tabletop. Wide steel plate distributes load, adding rigidity to the lightest bench top.
LEE APP BULGE BUSTER KIT w/o CARBIDE FACTORY CRIMP
Product Information
The Lee App Bulge Buster Kit and the appropriate Lee Carbide Factory Crimp Die, restore free function of rimless cases that have low base bulges. Low base bulges usually occur from chambers that do not fully support the cartridge or cases resized in carbide dies from manufacturers other than Lee. These show a noticeable stop ring near the base. You will most likely find cases with these problems in mixed range brass.
**Will work with the following cases:
- 380 ACP
- 10mm
- 40 S&W
- 41 AE (Use 40 S&W Factory Crimp Die)
- 45 ACP
- 45 GAP
- 45 Win Mag
The Lee Carbide Factory Crimp Die must be purchased separately.
LEE SPLINE DRIVE BREECH LOCK BUSHING 4-PACK
Product Information
Spline drive Breech Lock Bushings 4 pack. New, easy grip splined drive surface allows easy, accurate and fast die installation in your press. Reloading dies are confusingly similar looking, so we anodized and colored the bushings so you can “color code” your dies for quick positive identification. No need for lock rings on your dies with these quick-change bushings. Simply lightly tighten the clamp screw, and split collar will put a vice lock on your die. Loosen the screw, and the die will spin freely. Once set you’ll never lose position. They look so good and work so well, you’ll want them for all your dies.
Reviews
There are no reviews yet.