LEE 45 ACP/AR/SCHOFIELD/ MAG/ITALIAN CARBIDE SIZE DIE

Product Information

By separating the seating and crimping operation, you will benefit by a greatly simplified adjustment. More importantly, the Carbide Factory Crimp Die post sizes your case assuring you that any round that passes through the die will chamber properly in your gun.

Includes: Sizer/Decapping Die, Powder Through Expanding Die, Bullet Seat and Feed Die, Factory Crimp Die, Shellholder, Powder Dipper and Load Data. (Will also work for reloading 357 Magnum with minor adjustments.)

Product Information

Lee U Carbide Small Base Sizing Dies are great for reloaders looking for ultimate feeding reliability in their handgun. These dies undersize brass between .002" and .003" smaller than other Lee Carbide Sizing dies. Ammunition with undersized brass cases will chamber each and every time it is loaded out of a magazine giving reliable chambering each time a round is stripped out of the magazine or loaded into a cylinder. Competition shooters rely on having ammunition that will feed and chamber each round of ammunition as it is stripped out of the magazine. One of the other benefits reloaders have reported when using Lee U dies is increased consistency and accuracy in loaded rounds because these dies help increase and provide more consistent neck tension on loaded bullets. The solid carbide insert inside of these dies is ground to a special contour that does not leave a belt mark on the case. These carbide dies do not require lubricant while resizing, though a little case lube will make the sizing process easier. Shellholder sold separately. Technical Information: Material: Steel Die Type: U Carbide Small Base Sizing Die Accessories: Plastic Storage Container Notes: •Carbide sizing dies do not require case lube •Undersized dies size brass between .002" and .003" below SAAMI specifications, so ammunition will feed in chamber in tight chambers •Undersized dies work great for bringing back case tension to hold bullets on cases that may be thinner walled

Product Information

The Lee Carbide 3-Die Set is a great set of reloading dies for any reloader looking for a set of dies that will produce accurate ammunition for many years. Lee dies are made to exacting tolerances helping to create accurate ammunition every time they are used. Each Carbide 3-Die Set comes packaged with a carbide sizing die with decapping unit, powder through expanding die (used for expanding and belling the case mouth while charging the case with powder) and bullet seating die. Each die set comes packaged with the appropriate shellholder, powder dipper, load data sheet and plastic storage container. One of the great features of carbide dies is that they do not require the cases to be lubricated prior to use like non-carbide dies. Notes: Adjustable crimp from slight taper to full roll

Product Information

Lee Steel Die Sets have features identical to the Lee Carbide 3-Die Set except the case MUST be lubricated for sizing. Sizer Die, Powder Through Expander Die, Bullet Seater Die, Shellholder, Powder Measure, load chart and storage case included. Bullet seater die features and adjustable taper to roll crimp.