RCBS Expander-Decapping Unit .375 cal
$9.50
These replacement decapping units feature an expander rod, expander ball, and decapping pin. They are used in sizing dies to de-prime the case and expand the case neck in bottleneck cartridges. It is always a good idea to keep an extra decapping unit on-hand so you can ensure your reloading sessions do not get interrupted if you ever damage them during use.
- Factory Replacement Part
- Precision Machined to ensure concentricity
- Expander Rod, Expander Ball and Decapping Pin
- 0.375
- Limited Lifetime Warranty
1 in stock
Description
These replacement decapping units feature an expander rod, expander ball, and decapping pin. They are used in sizing dies to de-prime the case and expand the case neck in bottleneck cartridges. It is always a good idea to keep an extra decapping unit on-hand so you can ensure your reloading sessions do not get interrupted if you ever damage them during use.
- Factory Replacement Part
- Precision Machined to ensure concentricity
- Expander Rod, Expander Ball and Decapping Pin
- 0.375
- Limited Lifetime Warranty
Additional information
| Weight | .1 lbs |
|---|
Shipping & Delivery
Related products
Hornady – DELUXE DIE WRENCH
Product Information
The Hornady Lock-N-Load Deluxe Die Locking Ring Wrench is an ideal tool for your Lock-N-Load AP Press or for any Hornady die sets. The wrench is designed to hold the shellplate in place and keep it from slipping when adjusting the plate and securing it to the press. It also has three flats for tightening dies, spindle locks, and lock rings.
LEE – CASE COLLATOR FUNNEL
Product Information
The Lee Case Collator can fill all four Lee Case Feeder Tubes in just 10 seconds. Brass falls base down into the drop tubes, making progressive reloading with the Pro1000 or Load-Master presses that much easier. To use lay cases in collator and they will fall base down into the drop tubes (not included)
LEE STEEL BASE BLOCK FOR BENCH PLATE SYSTEM
Product Information:
The Lee Reloading Bench Plate is the perfect accessory for the reloader looking to quickly change between presses on their reloading bench. The steel blank is constructed of sturdy steel, and has a black powder-coat finish for added durability. The blank has pre-drilled mounting holes that will accommodate all Lee metallic reloading presses manufactured after 2007. The base blank also has integral tabs built in on the sides to ensure proper plate retention and position in the Bench Plate, allowing you to switch presses quickly and easily on any bench or stand. This blank base only is a great addition to the Bench Plate Kit to allow the reloader to quickly swap between multiple presses or reloading equipment. Hardware for mounting one reloading press is included.
Notes: Blank is pre-drilled to fit all Lee metallic reloading presses manufactured after 2007.
