LEE – BENCH PLATE

The Lee App Bulge Buster Kit and the appropriate Lee Carbide Factory Crimp Die, restore free function of rimless cases that have low base bulges. Low base bulges usually occur from chambers that do not fully support the cartridge or cases resized in carbide dies from manufacturers other than Lee. These show a noticeable stop ring near the base. You will most likely find cases with these problems in mixed range brass.

**Will work with the following cases:

• 380 ACP
• 10mm
• 40 S&W
• 41 AE (Use 40 S&W Factory Crimp Die)
• 45 ACP
• 45 GAP
• 45 Win Mag

The Lee Carbide Factory Crimp Die must be purchased separately. 

The Lee Reloading Bench Plate is the perfect accessory for the reloader looking to quickly change between presses on their reloading bench. The steel blank is constructed of sturdy steel, and has a black powder-coat finish for added durability. The blank has pre-drilled mounting holes that will accommodate all Lee metallic reloading presses manufactured after 2007. The base blank also has integral tabs built in on the sides to ensure proper plate retention and position in the Bench Plate, allowing you to switch presses quickly and easily on any bench or stand. This blank base only is a great addition to the Bench Plate Kit to allow the reloader to quickly swap between multiple presses or reloading equipment. Hardware for mounting one reloading press is included. Notes: Blank is pre-drilled to fit all Lee metallic reloading presses manufactured after 2007.