Sold out
DILLON SUPER-1050 SWAGE BACKUP BODY DIE
$24.00
Out of stock
Related products
Hornady – LOCK-N-LOAD DIE BUSHING (2-PACK)
Product Information
Lock-N-Load lets you switch from one die to another and begin reloading in seconds. No threading dies in and out or adjusting is necessary. The positive locking action of the bushings holds the dies in rock solid, perfect alignment. You'll want a Lock-N-Load bushing for every die you use. This is a 2 Pak.
LEE APP BULGE BUSTER KIT w/o CARBIDE FACTORY CRIMP
Product Information
The Lee App Bulge Buster Kit and the appropriate Lee Carbide Factory Crimp Die, restore free function of rimless cases that have low base bulges. Low base bulges usually occur from chambers that do not fully support the cartridge or cases resized in carbide dies from manufacturers other than Lee. These show a noticeable stop ring near the base. You will most likely find cases with these problems in mixed range brass.
**Will work with the following cases:
- 380 ACP
- 10mm
- 40 S&W
- 41 AE (Use 40 S&W Factory Crimp Die)
- 45 ACP
- 45 GAP
- 45 Win Mag
The Lee Carbide Factory Crimp Die must be purchased separately.
LEE BULLET SEATING MICRO- METER ADJ SCREW – RIFLE
Product Information
Lee Bullet Seating Micrometer Adjust Screw - Rifle
Set your bullet seating depth in .001" increments with Lee's new Bullet Seating Micrometer Adjust Screw. Infinitely adjustable, allows precision seating depth. Eliminates annoying clicks that prevent splitting thousandths. No clicks, just smooth. Black anodized, laser etched scale allows you to easily and quickly set your depth, and achieve repeatable results round after round. Works on all Lee bullet seating dies.
- Easy to use: Simply remove your existing adjustment screw, and thread in the micrometer.
- Infinite adjustment: Allows you to set your bullet seating depth precisely.
- Economically priced: You'll want one for every die
LEE BULLET SEATING MICRO- METER ADJ SCREW -LG RIFLE
Lee Bullet Seating Micrometer Adjust Screw - Large Rifle
Set your bullet seating depth in .001" increments with Lee's new Bullet Seating Micrometer Adjust Screw. Infinitely adjustable, allows precision seating depth. Eliminates annoying clicks that prevent splitting thousandths. No clicks, just smooth. Black anodized, laser etched scale allows you to easily and quickly set your depth, and achieve repeatable results round after round. Works on all Lee bullet seating dies.
LEE STEEL BASE BLOCK FOR BENCH PLATE SYSTEM
Product Information:
The Lee Reloading Bench Plate is the perfect accessory for the reloader looking to quickly change between presses on their reloading bench. The steel blank is constructed of sturdy steel, and has a black powder-coat finish for added durability. The blank has pre-drilled mounting holes that will accommodate all Lee metallic reloading presses manufactured after 2007. The base blank also has integral tabs built in on the sides to ensure proper plate retention and position in the Bench Plate, allowing you to switch presses quickly and easily on any bench or stand. This blank base only is a great addition to the Bench Plate Kit to allow the reloader to quickly swap between multiple presses or reloading equipment. Hardware for mounting one reloading press is included.
Notes: Blank is pre-drilled to fit all Lee metallic reloading presses manufactured after 2007.
LEE ULTIMATE TURRET PRESS 5 HOLE TOOL HEAD
5 hole turret and index rod for the Ultimate Turret Press or Ultimate Turret Press Kits. The round tool carrier is precision machined on all surfaces. Each die position is machined to accept any Lee Breech lock bushing.
